İçeriğe geç
akaturk Akademik ölçüm

Makale detayı · 2021 · article

Comparison of Ceramic and Coated Carbide Inserts Performance in Finish Turning of Hardened AISI 420 Stainless Steel

Dergi Politeknik Dergisi
ISSN1302-0900
YÖKSİS OpenAlex Açık erişim · diamond
Yıl2021
Atıf6OpenAlex
Yüzdelik%47,1
FWCI0,291,00 = dünya ortalaması

Veri kaynağı ayrımı

  • YÖKSİSYÖKSİS makale kaydı
  • YÖKSİS dergi adıPoliteknik Dergisi
  • OpenAlexOpenAlex zenginleştirmesi (özet, atıf, konular)
  • Semantic Scholaratıf sayısı (OpenAlex ile birleştirilmez)

Özet

OpenAlex İngilizce

Martensitic stainless steels have a high carbon amount that can be heat treated to increase their hardness. There are widely used in cutlery, needle valves, shear blades, dental and surgical equipment. In this study finish hard turning was performed on the AISI 420 stainless steel using ceramic and coated carbide inserts under dry cutting conditions. Depth of cut, feed rate, and cutting speed were selected as machining parameters, while surface roughness was chosen as machinability criterion. Taguchi L9 orthogonal array was selected for the design of the experiment to decrease the number of trials for reducing time and cost of manufacturing. The response surface methodology was utilized for determining a relationship among process parameters and output parameter. The analysis of variance results indicates that feed rate is the utmost factor on the surface roughness for both ceramic and carbide inserts with 86.56% and 80.57% contribution, respectively. The developed mathematical models for ceramic and coated carbide inserts are capable to predict surface roughness with 97.07% and 96.13% accuracy, respectively. Based on the desirability function and response optimizer of the RSM, 0.2 mm depth of cut, 250 m/min cutting speed, and 0.05 mm/rev feed rate were selected as optimum machining factors. Finally, the mean surface roughness for ceramic and coated carbide inserts calculated as 0.57 µm and 0.71 µm, respectively. Therefore, the ceramic insert exhibited better performance compared to the coated carbide insert.

Konular

Atıflar

OpenAlex cited_by_count. WoS veya Scopus atıf sayısı değildir; o kaynaklar için ayrı kolon yoktur.

6atıfOpenAlex · cited_by_count (önbellek / veritabanı)

Yerel katalogda bu makaleye atıf yapan 3 yayın (OpenAlex referans eşleşmesi; tam dünya listesi değildir).

  1. 2025 Eco-Friendly Drilling of AA 5052-H32 Alloy: Influence of Jasmine-Based Cutting Fluid on Surface Quality and Burr FormationAtıf 2 · OpenAlex
  2. 2023 Yük Belirsizliği Koşullarında Pratik Radyal Dağıtımlı Besleyicide DERlerin Tekno-Ekonomik ve Çevresel FaydalarıAtıf 1 · OpenAlex
  3. 2022 The Effect of the Parameters on Al 7075 Coated with MAO Method by Adding Nano Ti-PowderAtıf 0 · OpenAlex

Yazarlar

1
  1. MUHAMMED ARAS BAŞKENT ÜNİVERSİTESİ 1