Production, Characterization and Mechanical Behaviors of Electrolytic Metal-Coated Light Polymeric Cylinders for Photogravure Press Applications

OpenAlex İngilizce

Abstract Since precision engraving is essential for almost any product or application, it is important that the printing system produces smooth and clear prints. In this regard, the rollers are made of steel and polymeric materials. However, light cylinder production is economical, transportation costs are very low, and it provides ease of transportation and distribution for printing houses. However, regional chain orientations and cracks occur in the polymeric material on the conical surfaces of the cylinders with shafts longer than 1 m. Therefore, it is necessary to improve the surface properties of polymeric cylinder. In this study, electrolytic hard chromium (Cr) and soft copper (Cu) metal layers, conductive (Ni and Ag) paint and polyester coating were successfully fabricated on polymeric lightweight cylinders via electroplating, spraying and hand brushing techniques for photogravure press application. At the fabrication stage on the steel base cylinders, polyurethane has been molded by using an injection molding machine. In order to eliminate the porosities, where polyurethane takes place, polyester has been coated on the polymeric cylinder and consequently polyester has been painted with conductive dye to obtain the conductivity. Then Cu and Cr have been coated by using the electroplating method and gravured. At the end of final stage, the process has been completed with coating of Cr on the Cu layer/conductive paint/polyester coating/polyurethane substrate. Phase analysis, microstructures and mechanical properties of the obtained samples have been examined through XRD, SEM–EDS, surface roughness, microhardness, tensile, three-point bending, scratch and wear machines. As a remarkable result of these studies, correlations were established between the quality of the layers and the mechanical properties as innovative scientific approaches, and between the layers produced on an experimental basis and the samples produced on a fabrication basis, they were produced and used in high-quality multilayered architecture to engraving technology and then to the society because of its effectiveness.