Surface roughness and Streptococcus mutans adhesion on surface sealant agent coupled interim crown materials after dynamic loading

OpenAlex · İngilizce

Abstract Background With the application of surface sealant agents, smooth surfaces can be achieved in a shorter time when compared with conventional polishing. However, studies on the performance of these agents against chewing forces are not many. The purpose of this study was to evaluate the surface roughness and Streptococcus mutans adhesion on surface sealent coupled interim prosthetic materials after chewing simulation. Methods One hundred and twelve specimens were fabricated from two poly(methyl methacrylate) (Tab 2000, Dentalon Plus) and two bis-acryl (Tempofit, Protemp 4) interim crown materials and divided into 4 groups (n = 7) according to applied surface treatment: conventional polishing (control) and 3 surface sealant (Palaseal, Optiglaze, Biscover) coupling methods. The surface roughness values (Ra) were measured with a profilometer before (Ra0) and after aging through dynamic loading in a multifunctional chewing simulator for 10,000 cycles at 50 N load combined with integral thermocycling (between 5 and 55 °C) (Ra1). Specimens were incubated with Streptococcus mutans suspension and the total number of adherent bacteria was calculated by multiplying the counted bacterial colonies with the dilution coefficient. Results Surface sealant agent application significantly decreased the surface roughness compared with conventionally polished specimens, except for Optiglaze or BisCover LV applied Protemp 4 and Palaseal or Biscover LV applied Tempofit. Surface roughness after dynamic loading showed a statistically significant increase in all groups, except for the control groups of Tab 2000 and Protemp 4. A positive correlation was found between surface roughness values of interim prosthodontic materials and the quantitiy of Streptococcus Mutans. Conclusions Even though surface sealant agent application significantly decreased the surface roughness compared with conventionally polished specimens, dynamic loading significantly increased the surface roughness of all surface sealant coupled materials. The Ra values of all test groups were higher than the plaque accumulation threshold (0.20 µm). Streptococcus mutans adhered more on rougher surfaces.