İçeriğe geç
akaturk Akademik ölçüm

Makale detayı · 2017

Starch/PCL composite nanofibers by co-axial electrospinning technique for biomedical applications

Dergi

BioMedical Engineering Online

ISSN 1475-925X

YÖKSİS OpenAlex Açık erişim · gold SJR Q2 Atıf 97 Üst %10 Yüzdelik 92.4% FWCI 3.3
Yıl
2017
Tür
article

Veri kaynağı ayrımı

  • YÖKSİS YÖKSİS makale kaydı
  • YÖKSİS dergi adı BioMedical Engineering OnLine
  • Katalog eşleşmesi (ISSN) BioMedical Engineering Online
  • OpenAlex OpenAlex zenginleştirmesi (özet, atıf, konular)

Özet

OpenAlex · İngilizce

BACKGROUND: In this study, starch and polycaprolactone (PCL), composite nanofibers were fabricated by co-axial needle electrospinning technique. Processing parameters such as polymer concentration, flow rate and voltage had a marked influence on the composite fiber diameter. Fourier transform infrared spectroscopy, scanning electron microscopy (SEM), mechanical and physical properties (such as density, viscosity and electrical conductivity) of the composite fibres were evaluated. Moreover, a cell culture test was performed in order to determine their cytotoxicity for wound dressing application. RESULTS: The effect of starch ratio in the solution on the properties and morphological structure of the fibers produced was presented. With lower starch concentration values, the fibers have greater ultimate tensile strength characteristic (mostly 4 and 5 wt%). According to SEM results, it can be figured out that the nanofibers fabricated have good spinnability and morphology. The mean diameter of the fibers is about 150 nm. According to results of cell culture study, the finding can be determined that the increase of starch in the fiber also increases the cell viability. CONCLUSIONS: Composite nanofibers of starch/PCL have been prepared using a co-axial needle electrospinning technique. PCL was successfully encapsulated within starch. Fiber formation was observed for different ratio of starch. With several test, analysis and measurement performed, some important parameters such as quality and effectuality of each fiber obtained for wound dressing applications were discussed in detail.

Konular

Atıflar

OpenAlex cited_by_count. WoS veya Scopus atıf sayısı değildir; o kaynaklar için ayrı kolon yoktur.

97 atıf

OpenAlex cited_by_count (önbellek / veritabanı)

Yazarlar

  1. BARAN HEVAL KÖMÜR
  2. Feyza bayrak
  3. NAZMİ EKREN MARMARA ÜNİVERSİTESİ
  4. MEHMET SAYIP EROĞLU MARMARA ÜNİVERSİTESİ
  5. FAİK NÜZHET OKTAR
  6. zehra Sinirlioğlu
  7. SEVİL YÜCEL YILDIZ TEKNİK ÜNİVERSİTESİ
  8. OLCAY GÜLER
  9. OĞUZHAN GÜNDÜZ