Makale detayı · 2022
Effect of particles on tensile and bending properties of jute epoxy composites
Dergi
Materials TestingISSN 0025-5300
ISSN kaydı başka bir dergiye işaret ediyor; ad YÖKSİS kaydından.
- Yıl
- 2022
- Tür
- article
Veri kaynağı ayrımı
- YÖKSİS YÖKSİS makale kaydı
- YÖKSİS dergi adı Materials Testing
- Katalog eşleşmesi (ISSN) Materialpruefung/Materials Testing
- OpenAlex OpenAlex zenginleştirmesi (özet, atıf, konular)
Özet
OpenAlex · İngilizce
Abstract In this investigation, mechanical properties of composite materials produced from woven jute type were investigated. These composites were produced in the form of epoxy adhesive layers by using hand lay-up method in which aluminum, mica and ceramic particles were added into epoxy as a structural adhesive by 2, 4 and 6 wt%. Samples produced according to ASTM D procedures were subjected to tensile and three point bending loads to examine the effect of the particles. Experimental results were presented in tables and graphs. As a result, it was observed that the tensile and bending failure loads of the composite materials obtained by using the particle reinforced adhesive increased. Also, the biggest rise in tensile strength was achieved with 4 wt% aluminum and the biggest increase in bending strength was observed for 2 wt% aluminum particles.
Konular
Atıflar
OpenAlex cited_by_count. WoS veya Scopus atıf sayısı değildir; o kaynaklar için ayrı kolon yoktur.
246 atıf
OpenAlex cited_by_count (önbellek / veritabanı)
Yerel katalogda bu makaleye atıf yapan 25 yayın (OpenAlex referans eşleşmesi; tam dünya listesi değildir).
- Influence of carbon and glass fiber reinforced composite adhesive on the strength of adhesively bonded joints 2023
- Effect of nanoclay on the mechanical and thermal properties of glass fiber-reinforced epoxy composites 2024
- Investigation of the mechanical and thermal propertiesof epoxy adhesives reinforced by carbon nanotubes andsilicon dioxide nanoparticles in single-lap joints 2024
- Investigation of the mechanical and thermal properties of epoxy adhesives reinforced by carbon nanotubes and silicon dioxide nanoparticles in single-lap joints 2024
- The effect of fiber length and structure on joint strength in bonded joints with fiber-reinforced composite adhesive 2023
- The effect of fiber length and structure on joint strength in bonded joints with fiber-reinforced composite adhesive 2023
- The effect of different chemical surface-modified carbon fiber structure and ratio on bond strength in adhesive joints 2025
- The effect of different chemical surface-modified carbon fiber structure and ratio on bond strength in adhesive joints 2025
- The effect of different chemical surface-modified carbon fiber structure and ratio on bond strength in adhesive joints 2025
- Mechanical and thermal properties of short banana fiber reinforced polyoxymethylene composite materials dependent on alkali treatment 2024