İçeriğe geç
akaturk Akademik ölçüm

Makale detayı · 2021 · article

Numerical investigation of effect of different parameter on heat transfer for a Crossflow Heat Exchanger by Using Nanofluids

ISSN2148-7847
YÖKSİS OpenAlex Açık erişim · diamond TR Index
Yıl2021
Atıf11OpenAlex
Yüzdelik%69,3
FWCI0,881,00 = dünya ortalaması
Scopus (SJR)Q3

Veri kaynağı ayrımı

  • YÖKSİSYÖKSİS makale kaydı
  • YÖKSİS dergi adıJournal of Thermal Engineering
  • Katalog eşleşmesi (ISSN)Journal of Thermal Engineering
  • OpenAlexOpenAlex zenginleştirmesi (özet, atıf, konular)

Özet

OpenAlex İngilizce

The heat loads on electronic systems of an unmanned air vehicle are a significant problem. So enhancing heat transfer is a critical key to solve these thermal problems. This study is focused on increasing heat transfer rate in a crossflow heat exchanger by using nanofluids numerically. Effects of different Reynolds number of hot fluid (Re= 6000, 8000, 10000, 12000), different inlet velocity (Vair,inlet=30, 45, 60, 90 m/s) of cooling fluid, temperature of cooling air at different altitude (Tair,inlet=15, 10, 4, -17℃) and different types of nanofluids (Cu-H2O, CuO-H2O, TiO2-H2O, H2O) on heat transfer were studied numerically. Realizable k-ε turbulence model of ANSYS FLUENT computational fluid dynamics code was used for numerical analysis. It was obtained that increasing Reynolds number from Re=6000 to 12000 causes an increase of 44.65% on average Nusselt Number. Increasing inlet velocity of cooling air from 30 m/s to 90 m/s causes an increase of 6.96% on average Nusselt number. Increasing or decreasing air inlet temperature at different attitude does not cause any significant change on average Nusselt number. Using Cu-H2O nanofluid, which shows the best performance, causes an increase of 6.63% on average Nusselt number according H2O. Numerical results were also compared with experimental results at literature. It was obtained that numerical model can represent experimental results in a good level.

Konular

Atıflar

OpenAlex cited_by_count. WoS veya Scopus atıf sayısı değildir; o kaynaklar için ayrı kolon yoktur.

11atıfOpenAlex · cited_by_count (önbellek / veritabanı)

Yerel katalogda bu makaleye atıf yapan 2 yayın (OpenAlex referans eşleşmesi; tam dünya listesi değildir).

  1. 2023 Numerical Investigation of Cooling an Industrial Roller by Using Swirling JetsAtıf 4 · OpenAlex
  2. 2024 Evaluation of Heat Transfer and Flow Structures in Combined Jet Flow Channels with Copper Oxide-Water and Diamond-WaterAtıf 0 · OpenAlex

Yazarlar

2
  1. MUSTAFA KILIÇ ADANA ALPARSLAN TÜRKEŞ BİLİM VE TEKNOLOJİ ÜNİVERSİTESİ 1
  2. Ullah Atta 2